d4.100AB Four Channel Amplifier
Features
The delta (d) series amplifiers are Elektra’s reference car audio amplifiers.. The d4.100AB is a 4 channel class AB amplifier that outputs 100W RMS x 4 into 4 ohms.
The d series amplifiers feature high power and high efficiency MOSFET circuit design with overload, short circuit, thermal and low voltage protections. An optional bass remote control is available separately.
The d series amplifiers are designed with a double sided PCB in a symmetrical layout, Toshiba outputs, 105°C capacitors and Tiffany-style RCA connectors in a black and gold brushed aluminum chassis.
Amplifier Specifications
| d4.100AB | |
| Dimensions LxWxH (inches) | 14×9.2×2.2 |
| 4Ω Power @ 13.8V <1%THD | 100Wx4 |
| 2Ω Power @ 13.8V <1%THD | 150Wx4 |
| 1Ω Power @ 13.8V <1%THD | Not stable |
| 4Ω Bridged @ 13.8V <1%THD | 300Wx2 |
| Frequency Response (Hz) | 10-22k |
| LPF (Hz) | 30-4k |
| HPF/Subsonic Filter (Hz) | 30-4k |
| SNR (dB) | >90 |
| Efficiency | >70% |
| Minimum Load (Ω) | 2 |
| Thermal Protection | Yes (80°C) |
| Fuse Rating (A) | 80 |
Fuses must be installed within 18” of the battery and amplifiers.
Connections
- Output Terminals – connect to your speakers using at least 16AWG wire
- +12V Power Terminal – connect using a fused 4AWG to the battery +ve
- Remote – connect to the remote wire to turn the amplifier on/off
- Ground Terminal – connect using 4AWG to an electrical/chassis ground
- Line Input – connect to your source’s RCA cables
- Remote Bass Control – connect to your optional bass remote
- Low Pass Filter – adjust this to filter out unwanted high frequencies
- Subsonic Filter – adjust this to filter out unwanted low frequencies
- Bass Boost – adjust the bass boost level between 0dB to 12dB
- Master Input – connect to the master amplifier (only when strapping)
- Slave Output – connect to the slave amplifier (only when strapping)
- Power Indicator – this indicates if the amplifier is running optimally
- Protection Indicator – this indicates a problem. If this lights up, shut down the amplifier to troubleshoot the problem.
- Fuses – If blown, replace only with the same value and type of fuses
- Phase – adjust this to control the output polarity
- CH1/2 RCA input – connect to your CH1 and CH2 RCAs
- CH3/4 RCA input – connect to your CH3 and CH4 RCAs
- HPF/LPF switch – choose FULL, HPF or LPF crossover mode for CH1/2
- HPF/LPF switch – choose FULL, HPF or LPF crossover mode for CH3/4
- Gain Control – adjust this to control the gain for each channel pair
- Crossover – adjust this to control the HPF/LPF crossover frequency
Product Gallery
